Port Builder
Build a Flare Port
Custom 3D printed flare port kits tuned to your enclosure — better bass, cleaner output. Shape the port line in the section view, watch it build live, then export watertight STLs that sleeve together.
Port section
Straight line
Drag the lower circle to move the elbow and the top one to set the angle — the port rebuilds live. Orange is the 15 mm sleeve lap where each part slides over the next.
Your port
Settings
Port bore
Inside diameter 76 mm
Port length
The tuning length that runs inside the enclosure.
Mouth flare
Bottom end
Elbow
Straight — or drag the line in the section view.
Pipe sections
Auto splits the pipe into as few pieces as your build height needs. Each flared end is always its own part with a 15 mm sleeve lap, and every joint sleeves over the part below it.
Wall & printer
Drag to orbit · Scroll to zoom · Right-drag to pan
Bore
3.00"
76 mm inside
Port length
366 mm
Centre-line length
Overall height
366 mm
Mouth flare 110 mm
Parts
4 parts
207 × 216 mm of plate
Download a single part
How It Works
From Settings to Printable File
Set the bore & length
Pick 2" to 6" and dial in the tuning length that runs inside your enclosure.
Shape the flare & elbow
Roll or sharpen the mouth flare, flare the inner end, and bend the elbow for the fit you need.
Export & print
Download watertight STLs — one piece, or sleeved sections that slot together and fit your build plate.
Printed to Order
Want It Printed in PETG?
Set your port up above, then send us the settings and we'll print it in strong PETG and ship it ready to install.
Send Us Your Port Spec